USER MANUAL
Peplink Balance Series
http://www.peplink.com -236 / 261 - Copyright © 2015 Peplink
Appendix A. Restoration of Factory Defaults
To restore the factory default settings on a Peplink Balance unit, perform the following:
For Balance models with a reset button:
1. Locate the reset button on the Peplink Balance unit.
2. With a paper clip, press and keep the reset button pressed for at least 10
seconds, until the unit reboots itself.
For Balance/MediaFast models with an LCD menu:
Use the buttons on front panel to control the LCD menu to go to
Maintenance>Factory Defaults, and then choose Yes to confirm.
Afterwards, the factory default settings will be restored.
All user settings will be lost after restoring the factory default settings. Regular backup of configuration
parameters is strongly recommended.
To Next Page
Loading...
