peplink balance ONE - Email Notification

USER MANUAL
Peplink Balance Series
http://www.peplink.com -211 / 261 - Copyright © 2015 Peplink
24.4 Email Notification
The email notification functionality of the Peplink Balance provides a system
administrator with up-to-date information on network status. The settings for configuring
email notification are found at System>Email Notification.
Email Notification Settings
Email
Notification
This setting specifies whether or not to enable email notification. If Enable is checked, the
Peplink Balance will send email messages to system administrators when the WAN status
changes or when new firmware is available. If Enable is not checked, email notification is
disabled and the Peplink Balance will not send email messages.
SMTP Server
This setting specifies the SMTP server to be used for sending email. If the server requires
authentication, check Require authentication.
SSL Encryption
Check the box to enable SMTPS. When the box is checked, SMTP Port will be changed to
465 automatically.
SMTP Port
This field is for specifying the SMTP port number. By default, this is set to 25; when SSL
Encryption is checked, the default port number will be set to 465. You may customize the
port number by editing this field. Click Default to restore the number to its default setting.
SMTP User
Name /
Password
This setting specifies the SMTP username and password while sending email. These
options are shown only if Require authentication is checked in the SMTP Server setting.
Confirm SMTP
Password
This field allows you to verify and confirm the new administrator password.
Sender’s Email
Address
This setting specifies the email address which the Peplink Balance will use to send its
reports.
Recipient’s
This setting specifies the email address(es) to which the Peplink Balance will send email