peplink balance ONE - Traceroute Test; CLI (Command Line Interface) Support

USER MANUAL
Peplink Balance Series
http://www.peplink.com -220 / 261 - Copyright © 2015 Peplink
25.2 Traceroute Test
The traceroute test tool traces the routing path to the destination through a particular
Ethernet interface or a SpeedFusion
TM
connection. The traceroute test utility is located
at System>Tools>Traceroute.
Tip
A system administrator can use the traceroute utility to analyze the connection path of a LAN/WAN connection.
25.3 CLI (Command Line Interface) Support
The serial console connector on some Peplink Balance units is RJ-45. To access the
serial console port, prepare a RJ-45 to DB-9 console cable. Connect the RJ-45 end to
the unit's console port and the DB-9 end to a terminal's serial port. The port setting will
be 115200,8N1.
The serial console connector on other Peplink Balance units is a DB-9 male connector.
To access the serial console port, connect a null modem cable with a DB-9 connector
on both ends to a terminal with the port setting of 115200,8N1.