peplink balance ONE

To Next Page

To Previous Page

USER MANUAL

Peplink Balance Series

There are two persistent modes: By Source and By Destination.

By Source:

The same WAN connection will be used for traffic matching the rule and originating from the

same machine, regardless of its destination. This option will provide the highest level of

application compatibility.

By Destination:

The same WAN connection will be used for traffic matching the rule, originating from the

same machine, and going to the same destination. This option can better distribute loads to

WAN connections when there are only a few client machines.

The default mode is By Source.

When there are multiple client requests, they can be distributed (persistently) to WAN

connections with a weight. If you choose Auto in Load Distribution, the weights will be

automatically adjusted according to each WAN’s Download Bandwidth, which is

specified in the WAN settings page (see Section 12, Configuring the WAN

Interface(s)). If you choose Custom, you can customize the weight of each WAN

manually using the provided sliders.

15.2.3 Algorithm: Enforced

This setting specifies the WAN connection usage to be applied on the specified IP

protocol and port. This setting is applicable only when Algorithm is set to Enforced.

Matching traffic will be routed through the specified WAN connection, regardless of the

health check status of the WAN connection.

Starting from Firmware 5.2, outbound traffic can be enforced to go through a specified

SpeedFusion

connection.

15.2.4 Algorithm: Priority

This setting specifies the priority of the WAN connections used to route the specified

network service. The highest priority WAN connection available will always be used for

routing the specified type of traffic. A lower priority WAN connection will be used only

when all higher priority connections have become unavailable.

peplink balance ONE - Page 130