USER MANUAL
Peplink Balance Series
http://www.peplink.com -172 / 261 - Copyright © 2015 Peplink
Click Add Rule to display the following window:
Inbound / Outbound Firewall Settings
This setting specifies a name for the firewall rule.
This setting specifies whether the firewall rule should take effect.
If the box is checked, the firewall rule takes effect. If the traffic matches the specified
protocol/IP/port, actions will be taken by Peplink Balance based on the other parameters of
the rule.
If the box is not checked, the firewall rule does not take effect. The Peplink Balance will
disregard the other parameters of the rule.
Select the WAN connection that this firewall rule should apply to.
This setting specifies the protocol to be matched.
Via a drop-down menu, the following protocols can be specified:
TCP
UDP
ICMP
IP
Alternatively, the Protocol Selection Tool drop-down menu can be used to automatically
fill in the protocol and port number of common Internet services (e.g., HTTP, HTTPS, etc.)
After selecting an item from the Protocol Selection Tool drop-down menu, the protocol
and port number remains manually modifiable.
This specifies the source IP address(es) and port number(s) to be matched for the firewall
rule. A single address, or a network, can be specified as the Source IP & Port setting, as
indicated with the following screenshots:
To Next Page
Loading...
