USER MANUAL
Peplink Balance Series
http://www.peplink.com -174 / 261 - Copyright © 2015 Peplink
To change a rule’s priority, simply drag and drop the rule:
Hold the left mouse button on the rule.
Move it to the desired position.
Drop it by releasing the mouse button.
To remove a rule, click the button.
Rules are matched from top to the bottom. If a connection matches any one of the
upper rules, the matching process will stop. If none of the rules match the connection,
the Default rule will be applied.
The Default rule is Allow for both outbound and inbound access.
If the default inbound rule is set to Allow for NAT-enabled WANs, no inbound Allow firewall rules will be required
for inbound port forwarding and inbound NAT mapping rules. However, if the default inbound rule is set as Deny,
a corresponding Allow firewall rule will be required.
To Next Page
Loading...
