peplink balance ONE - Page 194

USER MANUAL
Peplink Balance Series
http://www.peplink.com -194 / 261 - Copyright © 2015 Peplink
Limit
Max Number
of Clients
Enter the maximum number of clients that can simultaneously connect to the wireless network
or enter 0 to allow an unlimited number of connections.
Firewall Settings
Firewall Mode
Choose Flexible – Allow all except… or Lockdown – Block all except… to turn on the
firewall. Once you save changes, the . Button will appear for you to create rules
for the firewall exceptions. See the discussion below for details on creating a firewall rule. To
delete a rule, click the associated button. To turn off the firewall, select Disable.
Firewall Rule
Name
Enter a descriptive name for the firewall rule in this field.
Type
Choose Port, Domain, IP Address, or MAC Address to allow or deny traffic from any of
those identifiers. Depending on the option chosen, the following fields will vary.
Protocol /
Port
Choose TCP or UDP from the Protocol drop-down menu to allow or deny traffic using either
of those protocols. From the Port drop-down menu, choose Any Port to allow or deny TCP or
UDP traffic on any port. Choose Single Port and then enter a port number in the provided
field to allow or block TCP or UDP traffic from that port only. You can also choose Port
Range and enter a range of ports in the provided fields to allow or deny TCP or UDP traffic
from the specified port range.
IP Address /
Subnet Mask
If you have chosen IP Address as your firewall rule type, enter the IP address and subnet
mask identifying the subnet to allow or deny.
MAC Address
If you have chosen MAC Address as your firewall rule type, enter the MAC address
identifying the machine to allow or deny.