This field allows you to confirm the new administrator password.
Read-only User Name is set as user by default, but can be changed, if desired.
This field allows you to specify a new user password. Once the user password is set, the
read-only user feature will be enabled.
This field allows you to confirm the new user password.
A web login session will be logged out automatically when it has been idle longer than the
Web Session Timeout.
Unlimited session timeout: 0 hours 0 minutes.
Default: 4 hours 0 minutes.
When External Authentication is selected, the web admin will authenticate using the
corresponding external server. Authenticated users are treated as either "admin" with full
read-write permission or “user” with read-only access. Local admin and user accounts will
be disabled. However, when the device is not able to communicate with the external server,
local accounts are enabled to allow emergency access. By default, it is set to Local
Account. Available options:
● Local Account
● RADIUS
This specifies the authentication protocol used. Available options
are MSCHAP v2 and PAP.
This specifies the IP address or hostname of the RADIUS server
host.
This setting specifies the UDP destination port for authentication
requests.
To Next Page
Loading...
Need help?
General