Their IP and DHCP settings will be kept intact.
When a VLAN is removed from InControl, it will be removed from the device as well.
If a VLAN gets defined on InControl, but not yet on the device, it will be defined on the device as
well.
Its IP address will follow the Default IP Address setting. DHCP server will be enabled with
default settings.
When a Switch is added to a group in InControl, a Management Port and Management VLAN
are imported from the local Switch to InControl.
Important: The Peplink switch is a Layer 2 switch. Any routing options that are shown in the
VLAN settings (like Inter-VLAN routing) do NOT apply to the switch. These settings are only
applied to Peplink Balance and Pepwave Max routers in the same InControl group supporting
that option.
By default, this VLAN is applied on any device that is added to this group.
Each VLAN can be applied to a selection of devices in the group by using tags.
Tags can be configured in the device details.
Detailed management VLAN network settings:
To Next Page
Loading...
General