When this checkbox is checked, the device's status information will be sent to the
Peplink InControl system.
This device's usage data and configuration will be sent to the system if you enable the features
in the system.
Alternately, you could also privately host InControl. Simply check the box beside the “Privately
Host InControl” open, and enter the IP Address of your InControl Host.
You can sign up for an InControl account at https://incontrol2.peplink.com.
You can register your devices under the account, monitor their status, see their usage reports,
and receive offline notifications.
Standalone menu options > System > Configuration
Backing up Peplink Balance settings immediately after successful completion of initial
setup is strongly recommended. The functionality to download and upload Peplink
Balance settings is found at System>Configuration.
To Next Page
Loading...
General