LACP - Link Aggregation
IEEE 802.3ad link aggregation enables you to group Ethernet interfaces to form a single link
layer interface, also known as a link aggregation group (LAG).
The maximum interfaces per LAG is 24.
The advantages of link aggregation in contrast with connections using an individual port include:
● higher throughput speed compared to an individual port
● higher accessibility
To configure a Link Aggregation Group (LAG), click Edit after selecting multiple ports.
Enable Link Aggregation by selecting the checkbox next to Link Aggregation.
The LAG can be set to Active or Passive.
LACP needs to be set to active on 1 side at least for LACP to work.
Details of Connected Clients and Hourly, Daily, or Monthly Power Usage for each Port is shown
in a graph on the same page.
To Next Page
Loading...
General