EasyManua.ls Logo

Percussionaire IPV-1C - Cleaning and Disinfecting Solutions; Changing PDM Batteries

Percussionaire IPV-1C
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
34
Chemical Class Active Ingredient
Bleach 5.25% Sodium hypochlorite
Alcohol 70% Isopropyl alcohol
Peroxide 3% Hydrogen peroxide
Benzyl Ammonium N-alkyl dimethyl ethyl benzyl ammonium chlorides
Chloride N-alkyl dimethyl benzyl ammonium chloride
Phenolic Ortho-phenylphenol
Ortho-benzyl-para-chlorophenol
Quaternary Ammonium Didecyl dimethyl ammonium chloride
Chloride Alkyl dimethyl benzyl ammonium chloride
Cleaning and Disinfecting Solutions
The Phasistron® 5 breathing circuit has been tested for biocompatibility with the
following cleaning solutions:
Changing PDM Batteries
A Low Battery indicator is displayed when battery capacity is nearing depletion.
1. Press on the PDMs bezel and twist counterclockwise approximately
20 degrees.
2. Gently pull on the multimeter to remove it from the housing.
3. Remove the two old batteries.
4. Install two new batteries. Note that the positive terminals face the same
direction. Wait 30 seconds until screen turns o.
5. Install the PDM back into the housing and twist clockwise until the
stop is felt.
6. See POST mode instructions to verify display operation.

Table of Contents

Related product manuals