EasyManua.ls Logo

PERDIX SHEARWATER - Storage and Maintenance; 9.1. Transmitter Battery Replacement; Servicing

PERDIX SHEARWATER
20 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Operating Instructions
Page 19
RevA
9. Storage and Maintenance
The Perdix AI dive computer and transmitter should be stored
dry and clean�
Do not allow salt deposits to build up on your dive computer�
Rinse your computer with fresh water to remove salt and other
contaminants� Do not use detergents or other cleaning
chemicals as they may damage the dive computer� Allow to
dry naturally before storing�
Store the dive computer and transmitter out of direct sunlight
in a cool, dry and dust free environment� Avoid exposure to
direct ultra-violet radiation and radiant heat�
9.1. Transmitter Battery Replacement
Transmitter battery type is 3V Lithium CR2�
1� Loosen the cap by turning counter-clockwise with a coin�
2� Remove old battery and discard according to local
regulations on lithium batteries�
3� Install the new battery, positive end rst.
4� Replace the o-ring (size AS568-016, nitrile A70) and
lightly lubricate it with a silicone grease� When installing
the o-ring, roll it over the lip from the coin slot side� Do not
roll it over the threads�
5� Install the battery cap by turning clockwise� Start slowly
to avoid cross-threading the cap. The cap should be ush
with the case when properly installed�
See the Perdix Operating Instructions for handset battery
replacement instructions�
10. Servicing
There are no user serviceable parts inside the Perdix AI or
transmitter� Do not tighten or remove the faceplate screws�
Clean with water ONLY� Any solvents may damage the Perdix
AI dive computer�
Service of the Perdix AI may only be done at Shearwater
Research, or by any of our authorized service centers�
Your nearest service center can be found at
www�shearwater�com/contact
Glossary
CC - Closed circuit� Scuba diving using a rebreather where
exhaled gas is recirculated with carbon dioxide removed�
GTR - Gas Time Remaining� The time, in minutes, that can be
spent at the current depth and SAC rate until a direct ascent to the
surface would result in surfacing with the reserve tank pressure�
NDL - No Decompression Limit� The time, in minutes, that can be
spent at the current depth until mandatory decompression stops
will be required�
O
2
- Oxygen gas�
OC - Open circuit� Scuba diving where gas is exhaled into the
water (i�e� most diving)�
PPO
2
- Partial Pressure of Oxygen, sometimes PPO2�
RMV - Respiratory Minute Volume� Gas usage rate measured as
the volume of gas consumed, adjusted as if at a pressure of one
atmosphere� Units of Cuft/minute or L/minute�
SAC - Surface Air Consumption� Gas usage rate measured as the
rate of tank pressure change, adjusted as if at a pressure of one
atmosphere (i�e� surface pressure)� Units of PSI/minute or Bar/
minute�
• Check the distance from transmitter to handset� If
range related dropouts are occurring during diving,
locating the transmitter on short length of high pressure
hose is possible to decrease the transmitter to handset
distance�