Peri MULTIFLEX - System-specific Safety; Additional PERI Product Information

4
System-specific
Retract components only when the
concrete has sufficiently hardened and
the responsible person has given the
instructions to strike.
Anchoring is to take place only if the
anchorage has sufficient concrete
strength.
During striking, do not tear off the
formwork elements with the crane.
The existing prop loads (see tables)
must be safely transferred by means
of sufficiently load-bearing slab props
or shoring systems.
When storing heavy items on the
formwork, the load-bearing capacity
must be taken into consideration.
Cantilevers may only be accessed after
bracing has been mounted.
The horizontal fixed position of the slab
formwork must be guaranteed. This is
given with circumferential walls and
pre-concreted beams. Otherwise, the
transfer of the horizontal loads has to be
guaranteed by means of other measures
supplied by the contractor, e.g. bracing.
Load assumptions for horizontal loads in
accordance with DIN EN 12812.
In order to avoid an overloading of the
integrated temporary props, the load-
bearing capacity of the slabs, bottom
plates and beams which have already
been completed must be activated. For
this, a free deflection possibility of these
components is required. This takes place
by releasing and re-installing all existing
temporary props, and is also required for
formwork systems where the prop head
is an integral part of the slab formwork.
For supporting pre-cast slabs, details
provided by the manufacturer are also
to be taken into consideration.
Safety Instructions
Introduction
– Assembly Instructions: VARIODECK
– Instructions for Use: Pallets and Stacking
Devices
– Instructions for Use: Stripping Cart
ASW 465
– Instructions for Use: Stripping Cart Alu
– PERI Design Tables
– MULTIFLEX brochure
– GT 24 Girder user information
– VT 20 Girder user information
– Assembly Instructions: PEP Ergo, PEP
– Assembly Instructions: MULTIPROP MP
– Assembly Instructions: MULTIPROP
System
Additional PERI Product Information
MULTIFLEX Girder Slab Formwork
Assembly Instructions for Standard Configuration