58 . Lambda 265, 365 and 465 ASX-260/280 AND ASX-520/560 Autosampler Users Guide
11. Insert reference sample in the Reference cell holder.
12. Insert reference sample in the set Blank Position (e.g. position 1) and sample in
each position of the Autosampler sample racks.
Ex)
13. Click Baseline.
14. The probe will move to the Blank position and start sucking, and after filling up the
flow cell, the Baseline will be measured.
15. After checking the baseline data, click Sample.
16. The probe will move to the first set sample position and start sucking, and after filling
up the flow cell, the sample will be measured. The sample measurement will continue
until the last sample measurement is completed.
17. Save or print the results after all the measurement are finished.
Sample
Reference
To Next Page
Loading...
Need help?
General
