64 . Lambda 265, 365 and 465 ASX-260/280 AND ASX-520/560 Autosampler Users Guide
Ex)
14. Click Baseline.
15. The probe will move to the Blank position and start sucking, and after filling up the
flow cell, the Baseline will be measured.
16. After checking the baseline data, click Standard.
NOTE:
User can set up to 10 standard samples in the Autosampler. The number of standards should
be matched with the number of concentration entry in the Quantification Standard set-up
windows.
17. The probe will move to the first set standard position and start sucking and after
filling up the flow cell and the standard will be measured. The standard measurement
will continue until the last standard measurement is completed.
18. After finishing all standards measurements, click Sample.
19. The probe will move to the first set sample position and start sucking and after filling
up the flow cell and the sample will be measured. The sample measurement will
continue until the last sample measurement is completed.
20. Save or print the results after finished.
To Next Page
Loading...
Need help?
General
