38 .
LS 55 User’s Guide
Single Position Cellholder (standard)
Figure 17 Single position cellholder
Description
The standard cellholder (L2250140) delivered with the LS 55 accepts 12.5 mm
square (10 mm pathlength) cuvettes, and can be thermostatted using circulated
water (as detailed in
Installing Thermostatting Tubing to Cellholders
on
page
45).
Installation and maintenance
This cellholder needs no alignment or setting up.
Maintenance consists of routine cleaning of the optical mirrors built into the
cellholder block, see
Care of Optical Mirrors Inside Cellholder Accessories
on
page
55) and cleaning the base and pressure bar if spillages occur (see
Resistance
to Solvents
on page 56).
To Next Page
Loading...
Need help?
General
