www.bringperlickhome.com
20
LOCK INSTALLATION &
REVERSING
A Door Lock Kit can be ordered as an
accessory. Two kits are available a right hand
opening and a left hand
opening kit. To install or remove the lock,
remove the three fasteners holding the Lock
Mechanism to the cabinet and the three
fasteners holding the Lock Bracket to the door.
ILLUSTRATION 11. DOOR LOCK INSTALLATION
SHELVING AND DRAWERS
Shelving
Perlick has three different types of shelving. All
designed to easily be moved and adjusted.
Cantilever
is stationary shelving. It can be
moved up and down for desired heights. Pick
up the shelving by pulling up and unhooking the
back hooks from the railing. Move to desired
height, then place the hooks in the railing and
set down.
Full extension Shelving
- Pull the shelf out to
its
farthest point. Locate the tabs in the middle on
both sides of the extenders. Press tabs and pull
shelf out.
Move each extender separately. Hold the
Middle of one extender, pull the front up then
rotate to the inside of unit. Once at a 45 degree
angle, pull up then pull out. Place extender at
desired height, at the 45 degree angle push in
the hook to the back rail, rotate toward wall and
set front section on the wall hook.
To return shelf, first push both extenders
completely in then line up the shelf grooves and
slide easily into the unit.
Wine Shelving
See Full Extension shelving.
Note: All shelving is inter-changeable with all
products.
Drawers
To remove, fully extend the drawers. Hold on to
both side and pull straight up and out.
To return drawers, fully extend the extenders.
Line up the back slots first, keep the extender
completely out, then set the back slots down into
place. Next, easily set down the front.
Caution: COMPLETELY EMPTY THE DRAWER
BEFORE REMOVING
To Next Page
Loading...
