www.bringperlickhome.com
22
disabled for this model.
PROPER PRODUCT STORAGE
Install items as desired. Do not block internal
louvers or fan guard openings, as this will
decrease operating performance.
CONTROL SETTINGS
The cabinet is shipped with the controller turned
ON. To turn the cabinet OFF or ON press the
blue soft button on the front face of the controller
(if the controller is turned off with power applied
to the cabinet the LED display will read OFF,
when turned on it will read a temperature). The
controller is located on the top front face of the
cabinet and is equipped with a tinted see-
through lens, which opens by pulling out on the
bottom of the lens and rotating upwards. Always
ensure lens cover is closed before closing door
to avoid damage to the controller or lens.
The electronic control comes preset for a
product temperature of approximately 38 F with
a product temperature adjustability range of
33 F to 45 F. To change temperature controller
settings see section “TEMPERATURE
CONTROLLER ADJUSTMENTS” on page 42.
IMPORTANT NOTE: THE LED DISPLAY IS
READING ACTUAL AIR TEMPERATURE NOT
PRODUCT TEMPERATURE. UNDER THESE
CONDITIONS, A 6 F AIR TEMPERATURE
SWING DOES NOT CHANGE THE ACTUAL
PRODUCT TEMPERATURE. PRODUCT
TEMPERATURE REMAINS AT A VERY
STABLE TEMPERATURE.
LIGHT SWITCH AND BULB
Your Single Door Refrigerator has an interior
light that is illuminated when the door is opened.
The cabinet also comes standard with a manual
light switch located next to the light for
displaying your products through a glass door.
Always ensure that the manual switch is in the
off position before closing a solid wood or
stainless steel door. If manual light switch is left
on for an extended period of time it may
increase the cabinet temperature, especially at
the top and cause the refrigeration system to run
longer.
SINGLE DOOR WINE
COOLER OPERATION
The Perlick Single Door Wine Cooler (H1W)
comes equipped with a state of the art
refrigeration system. The compressor is of a
variable speed variety, which automatically
changes speeds based on system conditions
and load. The cabinet is equipped with an
adjustable digital temperature controller and
LED display. The controller can be adjusted
through a range of 40 F to 68 F. The controller
has been factory set to modulate from 53 F to
57 F. To properly determine product
temperature see “CHECKING PRODUCT
TEMPERATURE” on page 44.
IMPORTANT NOTE: ALWAYS ALLOW
CABINET TO RUN FOR A MINIMUM OF 24
HOURS TO ALLOW TEMPERATURE
STABILIZATION AFTER START-UP BEFORE
STORING PERISHABLE ITEMS.
This cabinet is a frost-free model meaning the
evaporator (cooling coil) automatically defrosts
during off cycles. The controller also has a
manual defrost soft button on the front panel
signified by a melting snowflake, which has been
disabled for this model.
PROPER PRODUCT STORAGE
This wine cooler will accommodate 42 bottles of
wine. Specially designed full extension wine
racks allow for proper horizontal storage of the
wine. The cork remains moist, which keeps air
from entering the bottle. Do not block internal
louvers or fan guard openings, as this will
decrease operating performance.
CONTROL SETTINGS
The cabinet is shipped with the controller turned
ON. To turn the cabinet OFF or ON press the
blue soft button on the front face of the controller
(if the controller is turned off with power applied
to the cabinet the LED display will read OFF,
when turned on it will read a temperature). The
controller is located on the top front face of the
cabinet and is equipped with a tinted see-
through lens, which opens by pulling out on the
bottom of the lens and rotating upwards. Always
ensure lens cover is closed before closing door
to avoid damage to the controller or lens.
The electronic control comes preset for a
product temperature of approximately 55 F with
To Next Page
Loading...
