www.bringperlickhome.com
26
IMPORTANT NOTE: ALWAYS ALLOW
CABINET TO RUN FOR A MINIMUM OF 24
HOURS TO ALLOW TEMPERATURE
STABILIZATION AFTER START-UP BEFORE
STORING PERISHABLE ITEMS.
IMPORTANT NOTE: PERLCK’S MULTI-ZONE
UNITS ARE NOT DESIGNED FOR OUTDOOR
APPLICATIONS. INSTALLING MULTI-ZONE
UNITS OUTDOORS WILL VOID THE
WARRANTY.
This cabinet is a frost-free model meaning the
evaporator (cooling coil) automatically defrosts
during off cycles. The controller also has a
manual defrost soft button on the front panel
signified by a melting snowflake, which has been
disabled on this model.
PROPER PRODUCT STORAGE
The low temperature wine zone will
accommodate 42 bottles of wine. The high
temperature wine zone will accommodate 48
bottles of wine. Specially designed full extension
wine racks allow for proper horizontal storage of
the wine. The cork remains moist, which keeps
air from entering the bottle. Do not block internal
louvers or fan guard openings, as this will
decrease operating performance.
CONTROL SETTINGS
The cabinet is shipped with the controllers
turned ON. To turn the refrigeration system OFF
or ON press the blue soft button on the front
face of the low temperature wine zone controller
(if the controller is turned off with power applied
to the cabinet the LED display will read OFF,
when turned on it will read a temperature). The
low temperature wine zone controller is located
on the top front face of the cabinet above the left
door and is equipped with a tinted see-through
lens which opens by pulling out on the bottom of
the lens and rotating upwards. Always ensure
lens cover is closed before closing door to avoid
damage to the controller or lens. The warm
temperature wine zone controller appears
identical except it controls this zones cooling
system and is located above the right door.
The low temperature wine zone electronic
control comes preset for a product temperature
of approximately 55 F with a product
temperature adjustability range of 40 F to 56 F.
The warm temperature wine zone electronic
control comes preset for a product temperature
of approximately 65 F with a product
temperature adjustability range of 54 F to 68 F.
To change temperature controller settings see
section “TEMPERATURE CONTROLLER
ADJUSTMENTS” on page 42.
IMPORTANT NOTE: THE LED DISPLAY IS
READING ACTUAL AIR TEMPERATURE NOT
PRODUCT TEMPERATURE. UNDER THESE
CONDITIONS, A 4 F AIR TEMPERATURE
SWING IN THE WINE COOLER
COMPARTMENT DOES NOT CHANGE THE
ACTUAL PRODUCT TEMPERATURE.
PRODUCT TEMPERATURE REMAINS AT A
VERY STABLE TEMPERATURE.
LIGHT SWITCH AND BULB
Your Two Door Multi-Zone Wine Cooler has two
interior lights that are illuminated when each
respective door is opened. The cabinet also
comes standard with manual light switches
located next to each light for displaying your
products through a glass door. If manual light
switch is left on for an extended period of time it
may increase the cabinet temperature and in
turn product temperature, especially in close
proximity to the light at the top and cause the
refrigeration system to run longer.
TWO DOOR
REFRIGERATOR / WINE
COOLER OPERATION
The Perlick Two Door Refrigerator/ Wine Cooler
(H2RW) comes equipped with a state of the art
refrigeration system. The compressor is of a
variable speed variety, which automatically
changes speeds based on system conditions
and load. The cabinet is equipped with two
adjustable digital temperature controllers and
LED displays. The refrigerator zone controller
located above the left door can be adjusted
through a range of 33 F to 43 F. The refrigerator
zone controller has been factory set to modulate
from 34 F to 40 F. The wine cooler zone
controller located above the right door can be
adjusted through a range of 50 F to 60 F. The
wine cooler zone controller has been factory set
to modulate from 54 F to 56 F. To properly
determine product temperature see “CHECKING
PRODUCT TEMPERATURE” on page 44.
To Next Page
Loading...
