Permalert PAL-AT AT30K - Page 4

PAL-AT Installation Manual
4
4.2 Calibration Points ........................................................................................................... 21
4.3 Junction Boxes ............................................................................................................... 21
5 Cable Installation in Secondary Contained Piping ............................... 22
5.1 General .......................................................................................................................... 22
5.2 Pull Points ...................................................................................................................... 23
5.3 Cable Splices ................................................................................................................. 25
5.3.1 Factory Installed Fiber Pull Rope to Continuous Pull Wire Rope Splice .............. 25
5.3.2 Wire Rope to Wire Rope Splice ........................................................................... 26
5.3.3 Wire Rope to Wire Rope Splice (alternate).......................................................... 27
5.3.4 Wire Rope to Leak Detection Cables .................................................................. 28
5.4 Installation of the Continuous Pull Rope ........................................................................ 30
5.5 Installing Sensor and Jumper Cables ............................................................................. 32
5.6 Air Testing ...................................................................................................................... 35
6 Installation of Direct Buried Sensor Cable ............................................ 36
6.1 General .......................................................................................................................... 36
6.2 Installing the Sensor Cable ............................................................................................ 37
6.3 Above Ground Storage Tanks ........................................................................................ 40
7 Cable Installation for Raised Floor and Ceilings .................................. 42
7.1 General .......................................................................................................................... 42
7.2 Install the Sensor Cable ................................................................................................. 42
7.3 Locator Chart ................................................................................................................. 43
7.4 Calibration and end of run Access Points ...................................................................... 43
8 Cable Connectors ................................................................................... 44
8.1 General .......................................................................................................................... 44
8.2 Cable Connector Installation .......................................................................................... 44
8.2.1 CAGOLD and CATFH Connectors for Sensor Cables AGW-Gold, AGT-Gold,
TFH-Gold and TFH .............................................................................................. 44
8.2.2 CAJMP Connectors for Jumper Cables JMP-U/-UD ........................................... 47
8.2.3 CAJPP Connectors for Jumper Cables JPP and JMP ......................................... 49
8.2.4 CAGOLD Connector for ATP Cable .................................................................... 50
8.3 Shrink Tubing ................................................................................................................. 52
8.3.1 Cable Type TFH .................................................................................................. 52
8.3.2 Cable Types AGW-Gold, AGT-Gold and TFH-Gold ............................................ 53
8.3.3 Cable Types JMP-U/-UD, JPP and JMP ............................................................. 54
8.4 Cable and Connector Testing Procedures ..................................................................... 54
8.4.1 General................................................................................................................ 54
8.4.2 Continuity Test .................................................................................................... 54