12/27 Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
5. Maintenance indicator
Each time the ignition is switched on, the display indicates
the milage remaining before the next service.
When the kilometres to maintenance reaches zero, the
maintenance symbol remains lit on the display.
Maintenance counter reset
- Ignition off, hold down the control button (A) and turn
on the ignition, the distance unit flashes.
- Release the settings button.
- Hold down the settings button for more than 5 seconds
to switch off the maintenance symbol and set the
maintenance counter to zero.
- Turn off the ignition.
Choosing the display units
Frequency displayed on the service indicator
5000 km
You are advised to go to an approved
dealer to service the vehicle and erase
the service symbol.
You are advised to go to an authorised
dealer to have the vehicle serviced and
the message on the maintenance
indicator erased.
Choosing the distance unit is possible at
any time.
- With the ignition off, hold
down the settings button
(A), switch on the ignition
and wait for the
multifunction display to
come on.
- Select the unit by briefly
pressing the control
button, the distance unit
changes from "km" to
"miles" or inversely.
- Turn off the ignition.
If the distance unit is kilometres, the
outside temperature is displayed in °C.
If the distance unit is miles, the outside
temperature is displayed in °F
To Next Page
Loading...
Need help?
General
