24/27 Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
TYRES
Tyre pressure should be cold-checked regularly.
Incorrect pressure causes abnormal wear and affects
road behaviour, thus making driving dangerous.
If the wear limit on the tread is reached (T), you are
advised to go to a registered dealer to change the tyres.
.
BRAKE INSPECTION
Front brake pad wear
Rear brake pad wear
1
If one of the 2 brake pads is worn down to the minimum
dimensions (A), the 2 brake pads must be changed.
Rear brake lining wear
2
When it is no longer possible to adjust the control tension
nut, the brake pads are worn.
Actuate the brake control lever and check the position of
the wear mark on the cam tierod (B) compared to the
mark (C) on the engine housing.
If the cam tierod mark is aligned or with the wear mark or
exceeds it, the brake linings must be changed.
Tyre pressures
Front Rear
Solo 1.8 bars 2 bars
Pillion 1.8 bars 2.2 bars
When replacing tyres, you are advised to
mount tyres of the same brand and
equivalent quality. In case of puncture, it is
forbidden to mount an inner tube in a
tubeless tyre.
Tyres contain substances that are harmful
to the environment. Your dealer is
equipped to dispose of used tyres without
endangering the environment in
compliance with current standards.
T
We advise you to visit a registered dealer
for the replacement of these components.
1. Depending on model.
2. Depending on model.
-+
C
B
To Next Page
Loading...
Need help?
General
