22/27 Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
ENGINE OIL LEVEL
• Place the vehicle on its central stand on flat ground.
• Start the engine, let it run for a few minutes and then
stop it.
• Wait a few minutes for the oil to stabilise.
• Remove the cap/oil gauge (1).
• Wipe the cap/gauge and reinsert it into the filling orifice
without screwing it up.
• Remove the filler cap/gauge and check the oil level
• The oil level shall not be between the minimum (A) and
maximum (B) level marks without exceeding the latter.
• Add oil if necessary.
CHANGING THE ENGINE OIL
When the ambient temperature is below 0 °C, use an oil
of viscosity: 5W40.
The engine must be drained when it is warm to allow the
oil to run easier.
• Place the vehicle on its central stand on flat ground.
• Put on protective gloves.
• Remove the cap/oil gauge.
• Remove the drainage cap and its seal (2) and allow the
oil to drip into a recipient.
• Remove the strainer cap (3) and clean the strainer.
• Put back the drainage cap and strainer cap, fitted with
a new seal.
• Pour the required quantity of oil corresponding to t
he
manufacturer's standards into the filler hole.
• Start the engine and let it run for a short while.
• Remove the filler cap/gauge and check the oil level.
• Add oil if necessary.
• Check that the oil drain plug is sealed.
Too much oil will noticeably restrict the
vehicle's performance.
1
We advise you to go to a registered
dealer for draining.
Oil contains substances which are
harmful to the environment. Your dealer
is equipped to dispose of used oil without
endangering the environment and in
compliance with current standards
Engine oil
50 cc
SAE 5W40 Synthetic API SL/SJ
Quantity: 0.65 l at oïl change
125 cc
SAE 5W40 Synthetic API SL/SJ
or
SAE 15W50 Synthetic API SL/SJ
Quantity: 0.75 l at oïl change
°C
-30 -20 -10 0 10 20 30 40
°F
-22 -4 14 32 60 68 86 104
5 W 40
10 W 40
15 W 50
MULTIGRADE
2
3
To Next Page
Loading...
Need help?
General
