18/27 Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
INSPECTION BEFORE SETTING OFF
STARTING THE ENGINE
For greater safety, place the vehicle on its central stand
before starting the engine.
• Turn the ignition key to "ON".
• Ensure that the throttle is in the OFF position.
• Press one of the brake levers while pressing the starter
button. Do not press the starter for more than
10 seconds.
• Release the starter button as soon as the engine starts.
DRIVING
Starting off
The vehicle is on its stand with the engine running.
• Squeeze the brake lever with your left hand, grip the
grab handle with your right hand and push the vehicle
forwards to fold up the central stand.
• Sit on the vehicle.
• Release the left brake and turn the throttle slowly with
your right hand to start moving.
Accelerating and decelerating
To accelerate, turn the throttle towards (A). To slow down,
turn the throttle towards (B).
Component Checks
Fuel
• Check the fuel level in the tank.
• Top up with fuel if necessary.
• Check that there is no fuel leak.
Engine oil
• Check the level of the engine oil.
• If necessary, top up with the
recommended oil.
Disk brakes
• Check brake operation.
• Have an approved dealer check them
if they feel soft.
• Check brake pad wear.
• Check the level of brake fluid in the
reservoir.
Drum brakes
a
a. Depending on model.
• Check brake operation.
• If necessary adjust the control.
• Check the wear on the brake linings.
• Correct if necessary.
Lighting,
signalling,
indicators, horn
• Check operation.
• Correct if necessary.
Wheels and
tyres
• Check the tyre wear and condition.
• Check the tyre pressures cold.
• Correct if necessary.
Throttle
• Check the throttle handle turns
smoothly and returns correctly to its
starting position.
Steering
• Check the free rotation of the
steering.
Stand
• Check that the central and side
stands can be unfolded smoothly
a
.
• Operation of the ignition cut-out
a
.
If the engine does not start, release the
starter button and the brake lever, wait a
few seconds and try again.