TIGHTENING TORQUES
12
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
TIGHTENING TORQUES
Engine part
Drive pulley 17 m.daN
Driven pulley 9.6 m.daN
Clutch plate and shoes 7 m.daN
Belt anti-flapping roller 1.8 m.daN
Transmission cover;
• 6 mm diameter screw
• 8 mm diameter screw
1.2 m.daN
2.4 m.daN
Relay box cover 2.5 m.daN
Relay box drain plug 1.5 m.daN
Flywheel magneto cover 1.2 m.daN
Stator 1m.daN
Engine speed sensor 0.5 m.daN
Rotor 12 m.daN
Freewheel 1.4 m.daN
Starter motor 1.2 m.daN
Automatic tensioner 1.2 m.daN
Automatic tensioner plug 0.5 m.daN
Spark plug 1.2 m.daN
Decompressor valve balance weight 0.8 m.daN
Decompressor valve housing 3.2 m.daN
Chain tensioner 1.2 m.daN
Camshaft stop plat 0.5 m.daN
Cylinder head. (Guide pins) Procedure
Cylinder head bolts and nuts 1.2 m.daN
Cylinder head cover 0.8 m.daN
Inlet manifold 1.2 m.daN
Engine temperature sensor 1.1 m.daN
Injection ECU 1.2 m.daN
Injection rail 0.3 m.daN
Oil pressure switch 1.2 m.daN
Oil pump 0.6 m.daN
Oil filter 1.4 m.daN
Oil pump cover 0.9 m.daN
Crankcase 1.2 m.daN
Conrod and crankshaft assembly gear 1.1 m.daN
Balancing shaft 2.8 m.daN
Engine drain plug 2.5 m.daN
Water pump cap 0.4 m.daN
Water pump impeller 0.5 m.daN
Cooling system bleeder screw 0.3 m.daN
To Next Page
Loading...
Need help?
General
