ELECTRONIC INSTRUMENT FUNCTIONING PRINCIPLE
18
Reproduction or translation, even partial, is forbidden without the written consent of Peugeot Motocycles
Tr ipmeter.
The tripmeter displays and stores the number of kilometres travelled by the vehicle.
Changing the distance unit (km or miles) is as follows
- The ignition is switched off, press the control button while switching on the ignition, the distance unit
will flash.
- Select the unit by briefly pressing the control button, the distance unit changes from "km" to "miles"
or inversely.
- Switch off ignition to confirm.
Daily odometer.
The tripmeter displays and stores the number of kilometers travelled during a given period.
The daily odometer uses the same unit of measurement as the tripmeter.
Resetting the daily odometer:
- Press the control button (several times briefly) until the figures of the daily odometer flash.
- Pressing the control button for more than 3 s allows you to reset the daily odometer.
Fuel gauge.
In the fuel reserve position, the two last segments are lit and flash.
When the fuel tank is empty, all segments are off and the pump flashes.
Fuel gauge self-diagnostic
All segments flash if the fuel gauge or its wiring is faulty. Open circuit (wire cut).
The machine total kilometres remains in the memory when the battery is disconnected.
If the distance unit is kilometres, the outside temperature is displayed in °C.
If the distance unit is miles, the outside temperature is displayed in °F.
To Next Page
Loading...
Need help?
General
