Adjustment
11 - 29
11.05.10 Connecting rod (for PFAFF 1246 only)
● Loosen nuts 1 (right- and left-hand thread) when the cutting device is in the off-position.
● Measure the distance between shafts 2 and 3.
● Rotate connecting rod 4 according to the requirement.
● Re-tighten nuts 1.
Requirement
When the cutting device is in the off-position, the length of spacer rod 4 should be equal to
the distance between shafts 2 and 3.
Fig. 11 - 25a
2
3
4
1
1
X
X
To Next Page
Loading...
