HEIGHT AND ALIGNMENT OF CLOTH PRESSER BAR 5b
1. Remove: Mains lead.
2. Lift up lever "a" and remove lamp cover.
3. Unscrew screws "b" to remove bracket with lamp holder.
4. Make sure that the shank holder of presser foot is in its highest position.
5. Turn handwheel and bring feed dog below needle plate.
6. Loosen screw "c".
7. With lever "a" in its lowered position, push cloth presser bar down from the top so that
foot touches gauge.(No.10989)
8. Align the needle opening(s) of foot with those of the needle plate, and tighten screw "c".
9. Refit bracket with lamp holder.
To Next Page
Loading...
