HEIGHT OF FEED DOG 14
e
3.2~3.4mm
1.3mm
2mm
3mm
a
b
3.2mm
2mm
d
1. Remove: Mains lead - Sewing foot - Needles and rear cover
2. Set stitch length at "0.6" and differential feed at "1".
3. Turn the handwheel and bring feed dogs to their highest position.
4. Loosen screw "a".
5. Refit sewing foot, lower cloth presser bar to press gauge against needle plate.
6. Adjust feed dogs height with eccentric "b" to touch gauge and tighten screw "a".
7. Turn the handwheel towards you at least 3 complete turns and recheck adjustments.
8. Check gap between front and back feed dog (3.2 to 3.4mm).
9. If necessary, loosen screw "d", position gauge as per above sketch, push front feed dog
against gauge and tighten screw "d".
Note: Feed dogs should be both at the same level. If necessary, loosen screw "e" and adjust
rear feed dog level to front feed dog.
To Next Page
Loading...
Need help?
General
