1010
Looper cover
Push the looper cover 7 fully to the right and
then swivel it down. Five types of stitches
and their threading paths are portrayed in
color on the inside of the looper cover.
Note: The electricity supply of the machine
is cut off as soon as the looper cover or
swivel plate 12 is opened, for safety reasons,
i.e. sewing with the machine is no longer
possible.
Waste container
Insert the upper latch of the waste container
45 into the upper slot of the looper cover 7.
Apply pressure to the lower part of the
container until the lower latches fl ick into
place in the lower slots of the looper cover.
To remove the waste container, repeat this
procedure in the reverse order.
To Next Page
Loading...
Need help?
General
