1212
Spool disc/cone thread adapter
It is advantageous to use the spool dise
37 when sewing with large spools (5,000
10,000 m). To do this, place the cone thread
adapter 36 onto the spool pin 35. With
synthetic threads, the spool discs help
eliminate vibration of the cones/spools
aiding in smoother feeding of the threads.
Clip on thread guide
Use the clip on thread guide accessory when
sewing with decorative thread. Clip this onto
the telescoping thread guide 32 and thread
the machine as shown in the illustration. Use
the thread net and/or the thread unreeling
disc if needed.
Presser foot lifter
The presser foot can be raised and lowered
using the presser foot lifter 43. The
maximum vertical lift of 6.5 mm for the
presser foot for particularly thick fabrics can
be achieved by pressing the presser foot
lifter towards the rear.
Once an initial thread chain has been
created, the presser foot lifter no longer
needs to be raised if you continue working
with the same thread and presser foot. It is
suffi cient to gently lift the front part of the
presser foot using your thumb. Slide the
fabric under the raised part of the presser
foot. The fabric is automatically taken up and
fed into the machine when you activate the
foot control.
To Next Page
Loading...
Need help?
General
