3131
Thread chain cutter
After fi nishing the seam, sew an approx. 6”
- 8,1” (15 20 cm) long thread chain. Pull the
thread chain from the right to left over the
thread chain cutter 33. This will cut off the
thread chain.
Clamp spring for serging thread chain 25
Using this feature you can secure the thread
chain at the start of the fabric by pulling it
into the seam. Stitch off a minimum 4” (10
cm) long thread chain and raise the presser
foot. Remove the thread chain carefully from
the swiveling stitch width latch 22. Pull the
thread chain forwards and clamp it under
the spring.
Butt the fabric up against the front of the
needle(s). If necessary, make an approx. 1.5”
(3 cm) cut into the fabric along the cut line
using a pair of scissors. Lower the presser
foot and start sewing. The thread chain pulls
automatically into the inside of the seam.
Note:
This feature cannot be used for either the
2-thread safety-stitch seam, the 4-thread
safety-stitch seam, the 2-thread chainstitch
or for the rolled hem.
To Next Page
Loading...
Need help?
General
