3737
Press the power table 50 downwards into
the designated slot on the looper cover.
Close looper cover.
Note:
Please ensure that the upper overedge
looper is disengaged before attaching the
power table 50.
To return the machine to its previous
settings after sewing with the cover stitch or
two thread chainstitch:
Open the looper cover and remove the
power table.
Move the looper disengaging lever to the
right, thus re-engaging the upper overedge
looper.
Bring the swiveling stitch width latch into the
basic position (see page 31) and engage the
upper blade (see page 30).
Push the blade guard into the looper cover
and close the looper cover.
To Next Page
Loading...
Need help?
General
