1515
Changing the needle
Switch off the electrical power
To remove: Lower the presser foot and
move the needle(s) to the highest position
by turning the handwheel towards you. Push
the needle inserting tool (from the accessory
box 49) from below upward fully over the
needle. Loosen the fastening screw of the
needle (without removing it) with the Allen
key (behind the swivel plate) and pull the
needle down to remove.
To insert: Insert the needle into hole E of the
needle inserting tool, so that the fl at needle
shank K faces the fl at side L of the inserting
tool. Insert the needle fully into the holder
and tighten the fastening screws. Remove
the needle inserting tool.
Overlock needles types EL X 705, cat. no.
2002 are required for this machine.
To Next Page
Loading...
Need help?
General
