6-5
Deco Cover
Raise the upper knife (32) to its highest
position by turning the hand wheel. Now
push the knob for lowering the upper
knife (36) as far as it will go to the right.
Turn the knob towards you until the upper
knife is in its lowest position. The upper
knife is now disengaged.
3,5
Turn the seam width selection knob (22) to
set the seam width to 3.5 mm.
R
Use clearview foot R from the accessory
box. The machine is now set for thicker
thread for use with the decorative thread
guides.
If you press program selection key + again,
the machine is set for thinner thread for
use with the decorative thread guides.
To Next Page
Loading...
Need help?
General
