Pfaff creative 7560

Switch off the
master
switch. Raise
the
sewing
foot
lifter (23) and
turn the
hand-wheel until
the
take-up
lever
(33) has
reached its
highest
position.
Place the thread
on the
reel
holder
(36)
and fit a
corresponding
unwinding disk.
Now
pull
the
thread
into
guide
A. Then pass
the
thread to the
right or left along
thread
tension
disk
B
and downwards
through the
left-hand
threading slot (30).
Pull the
thread
around stop E
into the
right-hand
threading slot
and upwards
to
the take-up
lever
(33).The thread
must
be
pulled into
the
take-up
lever from
left to
right
and
downwards
again in the
right-hand
threading
Finally,
pass
the
thread from
the side behind
one
of the two
thread guides
(28).
Threading
the
needle
is
described
on the
following page.
Threading
the
needle
thread
—A
slot.
I
E
23