Pfaff hobbylock 4764 - 2-thread overlock stitch using 1 needle

19
1. Removing the right needle:
Create a wide 3-thread stitch by using only
the left needle and the left thread tension
(Dial 1).
The differential feed is normally set at “N”
(see p. 16).
2. Removing the left needle:
Create a narrow 3-thread stitch by using only
the right needle and the right thread tension
(Dial 2).
The differential feed is normally set at “N”
(see p. 16).
3-4 2-thread overlock stitch using
1 needle
1. Use 1 needle thread (left needle or right
needle) and lower looper thread.
Remove upper looper thread.
2. Attach 2-thread overlock convertor to the
upper looper.