10
A
B
3. Right needle threading (C)
For easy threading, disengage the moveable
blade by turning it upwards. Push the upper
blade holder screw (A) with the forefinger
of your left hand and turn the right end of
the holder (B) with your right fingers in the
direction of arrow (Fig. C).
Take the thread drawn from spool, and pass it
through thread guides (1)-(7) (Fig. A). Then
thread the eye of right needle (8) from front
to back using tweezers. Cut the thread leaving
about 10 cm (4”) of thread tail.
2-2 Changing thread
The following is an easy way to change
threads;
1. Cut the thread in use near the spool
(behind the telescopic thread stand). Place
the new thread on the spindle and tie it to
the end of the original thread.
Fig. C
4. Left needle threading (D)
Take the thread drawn from spool, and pass
it through thread guides (1)-(7), and thread
the eye of left needle (8) from front to back
(Fig. A, C).
Return the moveable blade to the cutting
position.
Make sure the blade is returned to the
cutting position before start sewing.
Otherwise, it may cause some serious
damage to your machine.
As the upper blade is sharp,
handle the moving part with care.