12
A
B
C
A
B
Operate your sewing machine
Winding the bobbin from the
spool pin
Place the sewing thread on the spool
pin (9). To guarantee free movement
of the thread and to give additional
hold to the thread spool, À t a spool cap
corresponding to the size of the thread
spool.
Threading
Place the thread into guide A and pull it
through opening B and to the right under
the hook C. Wind the thread clockwise a
few times around in the bobbin.
Winding
Switch on the main switch (1). Hold the
end of the thread À rmly and press the
foot control. The winding action will stop
automatically as soon as the bobbin is full.
Cut the thread, push the bobbin to the left
and remove it.
Don’t forget:
Turn the handwheel release disk (3) fully
back again. Then turn the handwheel (4)
towards you until it snaps into place.
To Next Page
Loading...
Need help?
General
