14
C
Operate your sewing machine
Winding through the needle
Even if the machine has been completely
threaded, you can still wind the bobbin.
First make sure to stop the needle from
moving while winding the bobbin (see
page 11).
Threading
Raise the presser foot lifter (15). Pass the
needle thread through the presser foot
and then upwards through the right
threading slot (12).
Now, pull the thread into the take-up
lever from left to right (10). The take-up
lever must be positioned at its very top.
Pass the thread to the right under the
hook C. Then wind the thread several
times around the bobbin.
Winding
Switch on the main switch (1) and press
the foot control. The winding action will
stop automatically as soon as the bobbin
is full. Cut the thread, push the bobbin to
the left and remove it.
Don’t forget:
Turn the handwheel release disk (3)
back again. Then turn the handwheel (4)
towards you until it snaps into place.
To Next Page
Loading...
Need help?
General
