Pfaff tipmatic 6122

~ --E
/\.
5
..,.".."
....-....
~
prog
I
- ... -
~
v
la
G - a 0
2-3
6
Ib
G
-
a -
2-3
Spec i al·
~ccessorie
Darning with the straight stitch
Insert the darning foot:
Set the needle at i ts highest point and push
the pin of the darning foot fully into the hole
C of the sewing foot holder. When doing this,
the guide fork G should position itself around
the presser bar. The wire E must be behind
the fixing screw F. Now tighten screw D.
Darning position:
Lower the presser-foot lifter while pushing it
lightly to the rear. This snaps the presser-foot
lifter into notch B (darning position).
- Place the darning work in the darning hoop.
- Drop
the feed dog .
- Pull up the bobbin thread and ho ld the
threads when you start sewing.
- Darn the damaged area by
guiding the
fabric back and forth evenly in the prescri-
bed direction
while ensuring that each line
ends with a small curve. This helps to avoid
the fabric ripping again.
- When you have finished sewing
the dama-
ged
area, rotate the fabric a half turn and
darn the area once again.
You determine the stitch length yourself by
moving
the fabric back and forth.
Tip: If you move the fabric too slowly, small
knots
will appear on the reverse side of the
fabric.
51