ENG
Operating Manual | Roof-mounted Cooling Unit | Multi Controller (MC) – 230 V | 086100023d 41/80
4.5.5.4 Mounting the cooling unit on the quick-change frame
Mount the quick-change frame on the switch
cabinet.
Mount the cooling unit on the quick-change frame.
Fig. 21: Mounting the bracket
Procedure
1. Place the quick-change frame (1) into the assembly cut-out (2).
– The assembly cut-outs and fastening points are identical with those for the assembly of the cooling unit alone, see
chapter "Dimensions of "Easy-Cut” unit cut-out", Page 33or "Dimensions of "Performance-Cut” unit cut-out",
Page 34.
2. Fasten the quick-change frame with screws and locking levers (3) to the switch cabinet from the inside.
– For a retrofit, use the screws and locking levers with which the cooling unit was previously fixed, see chapter "Unit
preparation – removing the front flap", Page 38.
3. Insert the cooling unit into the quick-change frame (4).
4. Lock the cooling unit in the quick-change frame. Use the enclosed socket wrench (5) for this.
The cooling unit is assembled and ready for electrical connection.
To Next Page
Loading...
