Pfeuffer HE lite User Manual

Operating instructions HE lite
© 2017 – Pfeuffer GmbH Revision 9 Page 19 of 28
7.6 Average
The HE lite is equipped with an average
function, allowing you to calculate
automatically the average of up to six
measurements. This function is
particularly useful, in case of very different
conditions (close to the forest, bottom of
valleys, etc.) in order determine the
average of the moisture reading to be
expected.
For the setting of the average function
please proceed as follows:
Select the function Average and confirm
by pressing .
Two parameters are indicated on the
display:
»AV f. Meas« means the number of
measurements included in the calculation
(adjustable from 1 to 6; factory setting
»0«, i.
e. the average calculation is
switched off).
»at
Display« means the number of
measurements of one product which are
indicated simultaneously (adjustable as a
function of »AV f.
Meas«). Figure »1«
means just the same indication as it is
during the standard measurement, only
the last reading and the number of values
included in the average calculation are
indicated. Figure »2« to »6« means that all
single readings included in the average
reading are indicated during the
measurement. In both cases the average
reading is indicated in the line before last
next to the selected product.
The following paragraph describes the
procedure of the average function and
the simultaneous presentation of 3
measurements:
Change the »AV f. Meas« to »3« by
means of the left button

.
→ AV f. Meas. 0
at Display 0
+
Set
–
Offset
→ Average
Illumination
↑
Set
↓
→ AV f. Meas. 3
at Display 0
+
Set
–

Pfeuffer HE lite Specifications

General

Brand	Pfeuffer
Model	HE lite
Category	Measuring Instruments
Language	English