Operating instructions sample cleaner MLN | Revision 3
10 Spare and wear parts
NOTICE
We particularly emphasise that spare parts and accessories that have not been supplied
by us are also not checked and approved by us. The assembly and/or use of such
products can hence affect the specified design properties of the sample cleaner MLN
under certain circumstances. Pfeuffer GmbH is not responsible for damages that occur
due to the use of non-original parts and non-original accessories.
Standard parts can be obtained at specialist shops.
The spare parts specified in the following are wear parts of sample cleaner MLN.
Lever switch - Short, angled with rubber bushes 2350 0254
Lever switch - Long, angled with rubber bushes 2350 0256
Lever switch - Long, straight with rubber bushes 2350 0365
Rubber bush for eccentric axle 3135 1740
Other spare and replacement parts are available on request. A complete list of spare parts is available and
can be separately requested.
NOTICE
Replacement works on the motor, V-belt gear and switch box should be carried out by
a skilled person only; refer to chapter 2.5.
In case of questions, please contact Pfeuffer GmbH.
11 Supplements and accessories
11.1 Feed hopper
A feed hopper with a capacity of 5 kg can be mounted on the deawner.
This way, the sample cleaner can be used for larger sample quantities,
e.g. for seed cleaning for trial lots.
11.2 Flow cup and bag holder
As the usual collecting pans are not suitable for larger sample quantities, another accessory is necessary
for operating the sample cleaner with integrated feed hopper:
Figure 21: Flow cups, bag holders (1-fold or 2-fold)
To Next Page
Loading...
Need help?
General
