PFT G 5 SUPER - Page 24

PFT G 5 SUPER Operating Manual Issued 11.2008
Knauf PFT GmbH & Co.KG
24
Connect pump motor (7-pin plug) and star wheel (black plug) to CADDY
Switch off compressor at Hand-O-Automatic switch.
Connect CADDY with electrical mains.
Follow these instructions:
Main reversing switch should be on position I
If red lamp lights up (change direction of rotation), PFT G 5 SUPER will not
turn on. Change direction of rotation at main reversing switch.
If the direction of rotation is wrong, follow these instructions:
You can lock the main reversing switch by pushing the direction plate either
to the right or to the left. With that you have chosen the direction of rotation.
If the switch is turned to the left, it can be turned back to O, but not to the
right side. The figure printed on the plate shows you in what position the
switch is locked.
Never let the pump run dry (remove blind plug).
If red lamp („change of direction“) does not turn off, see Faults an
d
Solutions
Press green pressure button (on).
Turn water pump switch to Automatic.