PFT G 5 SUPER Operating Manual Issued 11.2008
Knauf PFT GmbH & Co.KG
25
Press water flow button (1) (water pump should be running). Set
approximate amount of water with needle valve (2).
Setting the water factor
Adjust the expected water volume on the needle valve (2).
Observe the specifications of the material manufacturer.
During operation:
Every interruption of the spraying procedure results in minor irregularities o
the mortar consistency. These normalise, however, as soon as the machine
has been working for a while. Therefore do not change the water quantity
each time you detect irregularities, but instead wait until the consistency o
the material emerging at the spray gun has self-adjusted.
Connect the water hose of the water flow meter to the top water inlet of the
mixing tube.
WARNING!
By removing the 7-pin plug of the mixing pump you can interrupt powe
supply
(safety measure). To restart machine press green button (on).
Press water flow button briefly. The mixing chamber should contain enough
water so that the top of the rotor is covered. Watch out for loss of water. If
you lose water, the rotor may not be working properly.
Check water level (can be done with tilted pump motor).
The TWISTER D 6-3 pump should always be pre-wetted!
Set star wheel switch on “Hand“. You can set the star wheel on:
“HAND” (Manual Operation)
“0”
“AUTOMATIC”
To Next Page
