PFT G 5 SUPER - Page 41

PFT G 5 SUPER Operating Manual Issued 11.2008
Knauf PFT GmbH & Co.KG
41
Ltem. Qty Part no. Description
1 1 00 00 83 63
Motor connection cable 2.5m CEE plug 7 x 16 A 6 h red loop 5 mm
2 1 20 42 88 00 Plug CEE 7 x 16 A 6 h red no. 742
3 1 00 04 67 95
Geared motor ZF 38 5.5 kW 400 rpm with inclination switch RAL 2004
4 1 20 10 06 50
Mixing tube G 4/G 5 with adaptable suction flange RAL2004
5 1 20 10 09 00
Gasket motor hinge flange G 4 20 x 15 x 750
6 1 20 10 10 10 Splint D 4.5 with ring
7 1 20 10 12 02
Hinged bolt pin for motor hinged flange galv.
8 2 20 20 99 21 Collar nut M16 DIN 6331 galv.
9 2 20 20 11 00 Geka coupling 1" int. thread (packing unit = 10 pcs.)
10 3 20 20 17 00 Gasket Geka-coupling (packing unit = 50 pcs.)
11 1 20 20 16 50 Geka coupling dummy cover
12 4 20 20 99 20 Hex. nut M16 DIN 934 galv.
13 1 20 10 35 10
Mixing shaft reinforced for G 4/G 5 RAL2004
14 1 00 09 12 89 Cleaning shaft galv.
15 1 20 10 23 20 Mixing tube cleaner for D- and R-pumps
16 1 00 00 83 61
Motor connection cable 2.4m CEE plug 4 x 16 A 7 h black loop 4 mm
17 1 20 42 87 00 Plug CEE 4 x 16 A 7 h black no. 253
18 1 00 04 25 87 Geared motor 0.75 kW 28 rpm ZFQ38 RAL 2004
19 4 20 20 72 00 Safety nut M 8 DIN 985 galv.
20 2 20 20 78 05 Hex. screw M 8 x 40 DIN 933 galv. (packing unit = 10 pcs.)
21 1 20 10 29 01
Protection tube for hauling bracket G 4 RAL2004
22 2 20 20 78 01 Hex. screw M 8 x 35 DIN 933 galv. (packing unit = 10 pcs.)
23 1 20 10 08 01 Snap lock with safety device M14
24 1 20 20 85 22
Pin 8 H11 x 58 x 54 with washer and spline galv.
25 1 00 04 80 15 Cap PVC 1" (round, black)
26 1 00 04 76 21 Hinged flange with tube bar for G 54 RAL 2004
27 1 00 06 18 58 Hauling bracket cast G 4 with round funnel
28 2 00 02 32 71 Hex. screw M 8 x 40 DIN 931 galv.
29 2 20 20 72 00 Safety nut M 8 DIN 985 galv.