PFT G 5 SUPER - Page 49

PFT G 5 SUPER Operating Manual Issued 11.2008
Knauf PFT GmbH & Co.KG
49
Ltem. Qty Part no. Description
31 1 20 19 03 20 Tap 3/8" ext. thread with socket 10 mm
32 1 20 21 36 12 Water-/air hose 1/2" x 500 mm
33 1 00 01 14 92 Socket 1/2" x 80 no. 536 galv.
34 1 00 00 28 11 Nut 1/2" int. thread
35 1 20 20 38 00 Angle 1/2" int. thread-ext. thread 45 ° no. 121 galv.
36 1 20 21 52 00 Tap 1/2" without drainer
37 1 20 20 09 00 Geka coupling 1/2" ext. thread (packing unit = 10 pcs.)
38 1 00 01 99 13 Gauge 0-16 bar 1/4" at rear, D = 50 mm
39 1 00 00 93 67 Gauge 0-4bar 1/4" at rear, D = 50 mm
40 1 20 20 61 00 Hex. screw M 8 x 20 DIN 933 galv.
41 1 20 20 87 01 Hex. screw M 8 x 16 DIN 933 galv.
42 2 20 20 72 00 Safety nut M 8 DIN 985 galv.
43 1 00 04 80 16 Support red bronze manifold block CADDY G 5 RAL2004
44 1 00 03 92 86 Manifold block red bronze DK 06 FN-1/2" E
45 1 00 04 04 26 Inlet for control valve cpl. for manifold block red bronze
46 1 00 04 04 28 Bleed valve, manifold block, red bronze
47 1 20 15 61 00 Seal screw (plastic) with O-ring R 1/4" for pressure reducer
48 1 20 15 28 01 Magnet coil 42 V type 6213 A
49 1 00 01 96 07 Pressure reducing valve manifold block red bronze G 5
50 1 20 20 31 05
Nipple with conical socket 1/2" ext. thread with reducer nut 3/4" int. thread for
item no.20 15 77 00
51 1 20 20 17 00 Gasket Geka-coupling (packing unit = 50 pcs.)
52 1 20 20 09 00 Geka coupling 1/2" ext. thread (packing unit = 10 pcs.)
53 1 20 20 36 11 Angle 1/2" int. thread no. 90 galv.
54 2 00 05 91 96 Hose clamp 19-21
55 1 20 21 36 14 Water-/air hose 1/2" x 1800 mm
56 1 00 06 88 93 Hose socket 1/2" flat with nut 3/4"
57 1 00 07 27 86 Water counter for 1/2" tube max. 10 bar