PFT RITMO L plus - 2 Testing; 2.1 Testing by machine operator; 2.2 Periodic inspection; 3 General information

Mixing pump RITMO L plus FC-230V Overview – Operation
Testing
2020-11-09 7
2 Testing
2.1 Testing by machine operator
 Before the start of each work shift, the machine operator must test the effectiveness of the control
and safety devices as well as check the proper attachment of all protective devices.
 During operation, construction machines must be tested by the machine operator for their
operational safety.
 If defects are found in the safety devices or any other area that could impair safe operation, the
supervisor must be notified immediately.
 For defects posing a hazard to persons, the operation of the construction machine must be halted
until the defect is eliminated.
2.2 Periodic inspection
 Construction machines must be tested for safe operation by a specialist as the usage conditions
and operating circumstances require, but at least once a year.
 Pressure vessels must undergo the prescribed inspections by authorised experts.
 The inspection results are to be documented and must be stored at least until the next inspection.
3 General information
3.1 Information regarding the operating manual
 This manual provides important information and instructions on the correct use of the equipment.
Adherence to all defined safety and handling instructions is a prerequisite for a safe working
environment.
 Additionally, the on-site accident prevention regulations and general safety guidelines for the
equipment must be followed at all times.
 Read the manual carefully before starting any work! It is an integral part of the product and must be
kept near the machine and accessible to operators at all times.
 Always include the operating manual when transferring the machine to third parties.
 The diagrams and illustrations shown in the manual are intended for better understanding of tasks
and descriptions. They are not necessarily shown to the correct scale and may vary slightly from
the actual equipment used.
4 General information
4.1 Information regarding the operating manual
 This manual provides important information and instructions on the correct use of the equipment.
Adherence to all defined safety and handling instructions is a prerequisite for a safe working
environment.
 Additionally, the on-site accident prevention regulations and general safety guidelines for the
equipment must be followed at all times.
 Read the manual carefully before starting any work! It is an integral part of the product and must be
kept near the machine and accessible to operators at all times.
 Always include the operating manual when transferring the machine to third parties.
 The diagrams and illustrations shown in the manual are intended for better understanding of tasks
and descriptions. They are not necessarily shown to the correct scale and may vary slightly from
the actual equipment used.